dirna Bergstrom bycool blue line FLAT Instrucciones De Montaje página 27

FLAT
Assembly
Recommendations
• Before starting assembly, please read instructions
and follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely
connected, checking their correct fitting.
!
When installing Bycool Flat equipment in the ceiling,
protect the upper part of the cabin with a cloth or sheet
to prevent scratching.
Flat in the ceiling we should bear in mind that the
cabins are normally equipped with a hatch, and have a
structure which can support the weight of the equipment.
However, should it be necessary to cut open the ceiling,
or should the material in which the hatch is located not
be sufficiently resistant (for example ceilings of plastic,
fibreboard, etc), the installer should decide, under his
sole responsibility, whether the ceiling needs to be
reinforced in order to prevent deformation, breakage,
water leakage, etc, and prepare all means to prevent this
happening.
Warning
When installing the Bycool
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10
Open-jawed spanner 13
Open-jawed spanner 14
Scissors
Flexo-meter
Documentation included
Mounting instructions
User's guide
Troubleshooting
Warranty
! dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
! Please see product warranty procedure included in
Troubleshooting diagnosis.
! Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
! Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting Diagnosis.
27
Tools
220AA70011
220AA70003
220AA70004
220AA10010
! Warnings
EN
®