dirna Bergstrom bycool blue line FLAT Instrucciones De Montaje página 50

FLAT
EN
Valid for Standard and Globetrotter XL cabins
on the installation of power supply cables
1- Take the power supply cable from the equipment through to the vehicle battery, attaching the plastic supports
to the rear of the cabin and securing with flanges; then, with the cabin open, pass the cable through the bottom,
securing it with clamps and M4 screws; and through to the battery with flanges; use the same run as the
original cabling. (Clean the area before attaching the plastic supports). When the equipment is connected to
the battery, this will carry out a test of all the LEDs, and will go off.
IMPORTANT: Due to the complex system of electronic regulation of the equipment, the
current connection must be made directly to the vehicle battery, and not to any other point
which services other accessories of the vehicle, taking the precaution to not invert the polarity
when making the connection (2). Inverting the polarity may result in irreparable damage to the
electronics, which is not covered by the warranty.
IMPORTANT: Check the User Manual before starting up.
Detailed instructions
1
Power supply
cables
2
+
50
®
2
-