Abicor Binzel ABIPLAS WELD 250 MT Manual De Instrucciones página 31

®
ABIPLAS WELD 250 MT
Fig. 4 Steps for setting up the ABIPLAS
BAL.0311 • 2018-02-05
2–4
1
1 Insert the blunt end of the tungsten electrode about 5 mm into the back cap.
2 Insert both parts into the torch body and tighten with the back cap.
3 Unscrew the back cap half a turn anti-clockwise.
4 Insert the centring ceramics into the torch body from below.
5 Screw the alignment gauge onto the torch body as far as it will go. This
pushes the tungsten electrode back to the preset setting dimension.
NOTICE
• The standard setting dimension for the electrode setting is 3 mm.
6 Fully tighten the back cap. The tungsten electrode is clamped into place.
7 Unscrew the alignment gauge.
8 Attach the insulating ring and screw on the distributor ring and gas diffuser.
9 Insert the plasma nozzle and tighten with the fastening nut.
10Screw the gas diffuser back down against the fastening nut.
11 Screw on the gas nozzle.
NOTICE
A separate tool is available for detaching the distributor ring.
• Order data and ID numbers can be found in the current catalogue.
 4 Scope of delivery on page EN-8
5–7
3 mm
®
WELD 250 MT torch body
6 Putting into operation
8–11
EN - 11