Connecting The Coolant; Risk Of Burns - Abicor Binzel ABIPLAS WELD 250 MT Manual De Instrucciones

®
ABIPLAS WELD 250 MT

6.4 Connecting the coolant

1
1 Coolant return hose
2 Coolant supply hose
Fig. 7 Connecting the coolant
BAL.0311 • 2018-02-05
WARNING

Risk of burns

The cable assembly overheats if the coolant level is too low.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red
• Do not use deionised or demineralised water as coolant or for leak and
flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
Bleed the entire cooling system as follows when used for the first time and after
every cable assembly replacement:
1 Disconnect the coolant return hose (1) from the coolant recirculator (3) and
hold it over a collection receptacle.
2
3 Coolant recirculator
4 Control lead
6 Putting into operation
3
4
EN - 13