Burner Use - baltur TBML 600 ME Manual De Instrucciones

BURNER USE

Burner's operation is fully automatic; it starts up by enabling the
master and the control panel switch. Correct burner operation is
regulated by command and control devices, as described in the
chapter "Operation description". The "lock" position is a safety
position that the burner automatically assumes when a burner
or system component is not working properly. It is recommended
before starting again the burner "by releasing it" to check for faults
in the heating plant before restarting the burner. The burner may
stay in the lock position without any time limits. To release it, press
the red flashing button on the display of the BT 340 equipment
("ENTER" button).
Locking may also be caused by temporary faults; in these cases if it
is released, the burner will start up again in a regular way. If locking
continue to occur (3-4 times), do not continue with the operation
and, after having checked that the fuel arrives to the burner, ask the
intervention of the after-sales service in your area.
21 / 28
0006081557_201310