Tuning In To A Preset Station - JVC KD-LH1000 Manual De Instrucciones

3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
The display pattern automatically changes to the
small animation display and the preset number
flashes (then the previous display pattern resumes).
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
12

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 11.
Selecting a preset station directly
1
Select the band (FM1 – 3, AM).
FM1 FM2
2
Select the number (1 – 6) for the preset
station you want.
Note:
You can also use the 5 (up) or ∞ (down) buttons on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or ∞ (down) buttons,
the next or previous preset station is tuned in.
FM3 AM