SICE S 560 Manual De Instrucciones página 46

5) Position the tyre on the platform.
6) Turn the spindle until the clip reaches the 6 o'clock position.
7) Lower the spindle so that the clip can "enter" into the tyre, then move forward
until the rim touches the actual tyre itself (see Fig. M/2).
8) Turn the spindle clockwise while moving forwards, so that the clip takes up the
tyre bead.
Turn until the clip reaches the 11 o'clock position.
9) Lift the rim with the tyre connected.
The tyre will position obliquely to the rim (see Fig. M/3).
10) Take the mobile control unit to work position C.
11) Position the bead loosener disk against the second bead of the tyre and turn
the spindle until the clip is at the low point (at 6 o'clock).
12) Move the disk away from the wheel.
13) Remove the clip and replace it at 6 o'clock outside the second bead (See Fig. N).
14) Turn the spindle clockwise 90° to bring the clip to 9 o'clock.
15) Move the disk forward until it is about 1-2 cm inside the edge of the rim (See
Fig. N/2).
Begin to turn the spindle clockwise checking to make sure that, with a 90° turn,
the second bead begins to slip into the centre well.
16) When the bead is fully mounted, move the tool away from the wheel, tip it to
its non-working position and remove the clip.
17) Lower the spindle until the wheel rests on the platform.
18) Take the mobile control unit to work position B.
19) Close the arms of the spindle completely.
Support the wheel to prevent it falling off.
DANGER!
This operation can be extremely dangerous.
Do it manually only if you are certain you can keep the
wheel balanced.
For large and heavy tyres an adequate lifting device must
be used.
20) Translate the turntable to disengage the wheel.
21) Remove the wheel.
NB: If the tyre permits it, the operation described above can be speeded up by
mounting both beads at the same time:
- Follow the steps described under points 1÷7 described above but instead of attaching the clip to just the first bead (refer to point 8) clip
it to both.
- Lift the rim with the tyre hooked to it and turn it anticlockwise 15-20 cm (clip at 10 o'clock).
- Follow the steps described in points 15 ÷ 21 above.
S 560
46
ENGLISH • Instructions manual
M/2
M/3
N