Moving The Machine - SICE S 560 Manual De Instrucciones

ENGLISH • Instructions manual
5) Pheck the horizontal arm periodically.
N.B.: There may be some mechanical play at the tool-holder arm, or while moving
4
1
it, during the assembly and disassembly operations.
For longer component working life, it is advisable to ADJUST THE SLIDE SHOES as
described below:
a) Disconnect the machine from the mains.
b) Lift the tool-holder arm to the outside working position.
3
c) Loosen the guard fixing screws (1, Fig. J/4), remove the chain guard (2, Fig. J/4).
d) Loosen the nuts (3, Fig. J/4) for each upper slide shoe of the carriage (4, Fig.
2
J/4
J/4).
e) Loosen the four register locking nuts (1, Fig. J/5).
1
f) Screw each of the six slide shoe register screws (2, Fig. J/5) a quarter turn.
g) Tighten the four locking nuts of the upper slide shoes (3, Fig. J/4).
h) Tighten the four register locking nuts (1, Fig. J/5)
i) Refit the guard on the chain (2, Fig. J/4).
N.B.: If the adjustment is insufficient, and there is still play, adjust the screws
further, repeating the procedure described above until all mechanical play has been
2
eliminated.
J/5

15. MOVING THE MACHINE

The S 560 tyre changer has got a fork (1, Fig. AZ) which has been positionned there on purpose for moving the machine.
Follow these instructions:
1) Low the turntable holding arm (2, Fig. AZ) completely down.
1 2
2) Close completely the jaws of the chuck (3, Fig. AZ).
4
3) Bring the carriage (4, Fig. AZ) at the end of its travel, near the arm.
3
4) Insert into the lifting fork a hoisting belt (at least 60 mm wide and of
a lenght sufficient to bring the hook of the belt above the tyre changer).
5) With the special belt ring bring the 2 ends of the belt together and lift
with a sufficiently strong lifting truck.
AZ
59
S 560