SICE S 560 Manual De Instrucciones página 50

ENGLISH • Instructions manual
The first bead will be on the rim.
Remove the clip.
16) Take the mobile control unit to work position D.
17) Remove the tool from the tyre.
18) Move the tool carrier arm to its non-working position.
Move it to the outside plane of the tyre.
19) Turn the tool 180°.
20) Take the mobile control unit to work position B.
21) Turn the spindle until the valve hole is at the bottom (6 o'clock).
22) Lower the spindle until the tyre is pressed down against the platform.
Move the spindle leftwards to provide sufficient space to insert the inner tube.
NB: The valve hole may be asymmetrical to the centre of the rim.
In this case position and insert the inner tube as shown in Fig. T.
Insert the valve through the hole and fix it with its locking ring.
23) Place the inner tube in the centre well of the rim.
NB: to facilitate this, turn the spindle clockwise.
T
24) Turn the spindle until the valve is at the bottom (6 o'clock).
25) Inflate the inner tube a little (until it has no folds) so as not to pinch it while
mounting the second bead.
26) Attach an extension to the valve and then remove the locking ring.
NB: The purpose of this operation is to allow the valve to be loose so that it is not
ripped out during second bead mounting.
27) Take the mobile control unit to work position C.
28) Lift the wheel again and attach the PC clip outside the second bead about 20
cm to the right of the valve (See Fig. U).
29) Turn the spindle clockwise until the clip is at 9 o'clock.
30) Move the tool carrier arm (14, Fig. D) to its working position.
31) Bring the tool forward until the red reference dot is lined up with the outside
edge of the rim and about 5 mm from it. U
32) Turn the spindle a little clockwise until you can insert the bead guide lever into
its seating on the hook tool (See Fig. V).
33) Pull back on this lever which will guide the bead into centre well.
Continue to turn the spindle until the tyre is completely mounted on the rim.
34) Remove the PC clip. Remove the hook tool by turning the spindle anticlockwise
and moving it towards the outside.
35) Tip the tool carrier arm to its non-working position.
36) Lower the spindle until the wheel rests on the platform.
V
50
S 560