Safety Devices; Transport; Installation; Installation Place - SICE S 560 Manual De Instrucciones

ENGLISH • Instructions manual
The S 560 tyre changer has a number of safety devices designed to guarantee the utmost op-
erator safety:
1. Check valve on the spindle opening hydraulic line (inside the swivel connector, see fig. B/1).
This prevents the wheel from falling from the spindle if the hydraulic line is accidentally broken.
2. Pilot operated dual seal check valve (see Fig. B/2).
This prevents the spindle carrier arm from dropping if the hydraulic circuit accidentally breaks.
B/2
CAUTION: Removing or tampering with the safety devices is in violation of
European safety regulations and releases the manufacturer from all liability
for damage caused by or related to such actions.
The machine is delivered in a wooden box with pallet.
Shipping weight is 1610 kg.
The machine must be handled with a fork-lift truck with the forks positioned as shown in
the figure A/2.
Choose the place the machine is to be installed in compliance with current work place safety regulations.
The floor should not be broken or uneven so that the machine will be stable.
If the installation is outdoors, it must be protected by some kind of roofing against rain.
The following work environment conditions are applicable:
Relative humidity: from 30-95% without condensation;
Temperature: from 0-55° C.

4. SAFETY DEVICES

3. Pressure relief valve factory set at 130 bar ±5% (See Fig.
B/3).
This limits the pressure in the hydraulic circuit and ensure correct
operation of the plant.
If the tyre changer is equipped with the accessory RC Radio
control the mobile control box is connected to the body of S 560
through a steel wire which prevents the operator from going away
and from working without seeing the machine.

5. TRANSPORT

6. INSTALLATION

6.1 INSTALLATION PLACE

35
B/1
B/3
A/2
S 560