Remote Administration; Internet Connection; What You Need - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Remote Administration

While we are suggesting you connect via USB to update settings in the ATEM Streaming Bridge,
you can also connect via Ethernet over your local network. However this can create a security
issue where someone could run the ATEM Setup and change the ATEM Streaming Bridge
settings. To increase security, there is a setting to disable remote administration via Ethernet so
you can only change the ATEM Streaming Bridge via a direct USB connection.
Disable remote configuration via Ethernet if you want to change settings via USB only

Internet Connection

The most exciting way to connect ATEM Streaming Bridge is via the Internet. This is a little more
tricky, because you have to make sure an ATEM Mini Pro can find the ATEM Streaming Bridge,
from anywhere in the world. It's a big world, so there is a few more settings you will need to
update to make this work.
However because ATEM Mini Pro has a broadcast quality hardware streaming engine built in,
we can take advantage of this and get very good quality video links worldwide. This allows you
to set up a network of studios who can stream to each other.

What you need

To connect to the Internet, you will need a connection to the Internet from both your
ATEM Streaming Bridge and the ATEM Mini Pro that will stream to it. You will also need to
have a public IP address for your ATEM Streaming Bridge as your ATEM Mini Pro needs to
connect to it, and you need a fixed address that won't change over time.
The problem is your ATEM Streaming Bridge is on your local Ethernet network, however you
need it to be visible on the internet. ATEM Streaming Bridge uses port forwarding in your
internet firewall to allow the ATEM Mini Pro on the internet to connect via your internet
connection to the ATEM Streaming Bridge. If this is not set up, then the ATEM Mini Pro won't be
able to find the ATEM Streaming Bridge.
What this means is you need to ask an internet provider, or your network administrator to set up
port forwarding on your internet connection to "TCP port 1935". They will know what that means!
The good news is the ATEM Streaming Bridge will also attempt to set up this port forwarding
feature for you, as most internet connections and firewalls have a protocol for setting up the
port forwarding automatically. This means it's possible the ATEM Streaming Bridge will
communicate with your network gear and try and set this up for you as you set up using the
ATEM Setup utility.
Creating Video Links with ATEM Streaming Bridge 117