Controlling Hyperdecks With External Hardware Panels - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

When you select a HyperDeck, you'll see information about the currently selected clip such as
the name and length, as well as time elapsed and time remaining. Below this you'll see the
control buttons.
Record Click on this button to start recording on your HyperDeck.
Click again to stop recording.
Previous Clip Moves to the previous clip in your HyperDeck's media list.
Play Clicking 'play' once initiates playback, clicking it again stops playback. If you
have 'auto roll' enabled in your HyperDeck settings, playback will commence
automatically when your HyperDeck is switched to the program output.
Next Clip Moves to the next clip in your HyperDeck's media list.
Loop Click 'loop' once to loop the currently selected clip, and again to loop all of the
clips in your HyperDeck's media list.
To move through a clip use the shuttle/jog slider underneath your HyperDeck's control buttons.
This lets you move quickly, or shuttle through a selected clip, or jog frame by frame. You can
switch between these modes with the buttons next to the shuttle/jog slider.
Choose between shuttle and jog transport controls with the
buttons to the left of the transport slider. Adjust the slider left
and right to move forward or backwards through your clip.
The clip list below the transport control shows all of the clips currently available on the selected
HyperDeck. You can expand or collapse the list by pressing the arrow to the right of the clip list.
Playback
To play media on your HyperDeck, simply switch the HyperDeck source to the preview output
and select the clip you want to show. Use the transport controls to cue to the preferred point in
your clip. When you switch your HyperDeck to program output, the 'auto roll' feature will
automatically start playback from this point.
If you want to manually trigger the playback, for example holding on a still frame then rolling,
simply disable the respective HyperDeck's auto roll checkbox in the 'HyperDeck' tab in
ATEM software's 'settings' menu.
Recording
To record to a HyperDeck with a formatted disk inserted, simply press the 'record' button in the
HyperDeck palette transport controls. The 'time remaining' indicator in the HyperDeck palette
will let you know the approximate recording time remaining in the SSD.

Controlling HyperDecks with External Hardware Panels

If you are using an external ATEM hardware panel, you can control any connected HyperDecks
using the hardware panel. Once you have connected your HyperDecks to your ATEM Mini as
described in the 'connecting HyperDecks' section, you can use the system control buttons and
LED menu on your panel to set up and control each HyperDeck.
HyperDeck Control 125