Setup And Operation; Switch Settings - brennenstuhl SOL 80 ALU IP 44 Instrucciones De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
066411 Solar-Leuchte SOL 80 ALU 29.01.16 10:10 Seite 11
Directions for use

SETUP AND OPERATION

After successful installation connect the solar module cable with the lamp.
The solar LED lamp is now ready to use.
Important:
Remember to charge the batteries before first use of the lamp. The switch must be in
OFF position. Charging with the solar module takes approximately 3-4 sunny days.

SWITCH SETTINGS:

On top of the lamp casing you find the main switch with two possible settings (Figure C):
ON:
Position when switched on.
The batteries are charged via the solar module, the lamp is activated via the
motion detector.
OFF: Lamp and movement detector are switched off, battery charging via solar module
still active.
Position during delivery and recommended position during longer periods of
non-use.
Switch position during fast battery charge without operational lamp.
ON
OFF
Figure C
MOVEMENT DETECTOR
This is a passive infrared sensor detecting motion due to heat radiation changes within
the protected area, which turns the lamp on/off.
Set the main switch after initial charging to ON position.
Turn the movement detector until you have access to the control knobs (see Figure D).
LUX
SENS
Figure D
TIME
SOL 80 ALU IP 44
11

Publicidad

Tabla de contenido
loading

Tabla de contenido