BWT Infinity A Instrucciones De Montaje página 16

GB GB
GB GB GB
16 16 16 16 16
Startup Startup
Startup Startup Startup
Check that the filter and flushing water pipe have
been properly installed.
3 3 3 3 3
Slowly open the stop valves up- and downstream
of the filter. Deaerate the pipework at the next bleed
point downstream of the filter, and drain water
briefly.
Check the seals of the installation and filter for
leaks.
24 V 24 V 24 V
24 V 24 V
Insert the cable plug connector of the transformer
into the socket (24V
Plug in transformer with plug (3 3 3 3 3 ). The first back-
washing cycle is performed automatically (during
backwashing the illuminated segments on the dis-
play turn).
The factory setting
Infinity A only Infinity A only Infinity A only
Infinity A only Infinity A only
The required backwash interval must be set on
the filter.
Set Set
Press Set Set Set to set the interval
Set Set
Set Set Set
Key
Set Set
Press Set Set Set
Display dots flash;
device is in programming mode
Pressing the Set
of h h h h h (hours) or d d d d d (days).
The hours h h h h h run from 1 1 1 1 1 - 24
from 2 2 2 2 2 - 56
Press the Set
set.
The value is saved 10 seconds after the last input.
The display dots go out. The unit backwashes.
The filter is ready for use.
24V 24V). 24V 24V
7 8
(7 days) appears.
for 5 sec.
Set key again steps up the number Set Set
Set
24 24, followed by days d d d d d 24
24
56 56
56 56, followed by the hours again etc.
Set Set
Set Set key until the desired value has been
Display
7 d 7 d
7 d 7 d 7 d