Stihl HT 75 Manual De Instrucciones página 50

Ocultar thumbs Ver también para HT 75:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Note that the chain continues to run for a
short period after you let go of the
throttle trigger (flywheel effect).
Check idle speed setting: The chain
must not move when the engine is idling
with the throttle trigger released.
To reduce the risk of fire, keep hot
exhaust gases and hot muffler away
from easily combustible materials (e.g.
wood chips, bark, dry grass, fuel).
Holding and Controlling the Power Tool
Always hold the unit firmly with both
hands – right hand on the control handle,
left hand on the drive tube – even if you
are left-handed. Wrap your fingers
around the control handle and drive
tube.
48
Machines with telescoping shaft: Only
extend the telescoping shaft as far as
necessary for the cutting work that
needs to be done.
During Operation
Make sure you always have good
balance and secure footing.
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the slide control
/ stop switch to STOP or 0.
This power tool is not
insulated against electric
shock. To reduce the risk
of electrocution maintain
a minimum clearance of
15 meters from electric
power lines.
15m (50ft)
To reduce the risk of injury from falling
objects and thrown pieces of wood, do
not allow any other persons within a
radius of 15 meters of your own position.
To reduce the risk of damage to
property, also maintain this distance
from other objects (vehicles, windows).
Maintain a minimum clearance of
15 meters between the bar nose and
electric power lines. Electricity can jump
considerable distances by means of
arcing. Higher voltage increases the
distance electricity can arc. Have the
power switched off before starting
cutting work in the immediate vicinity of
power lines.
To reduce the risk of injury, shut off the
engine before changing the saw chain.
Make sure the idle speed setting is
correct. The chain must not run when
the engine is idling with the throttle
trigger released.
It the chain still rotates, have your dealer
make proper adjustments or repairs.
Check and correct the idle speed setting
regularly.
Never leave a running power tool
unattended.
Take special care in slippery conditions
(ice, wet ground, snow) – on slopes or
uneven ground.
Watch out for obstacles: Roots and tree
stumps which could cause you to trip or
stumble.
When working at heights:
Always use a lift bucket
Never work on a ladder or in a tree
Never work on an insecure support
Never operate your power tool with
one hand
HT 75

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido