Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Hold the unit firmly with your left
N
hand on the fan housing – your
thumb should be under the fan
housing.
Pull the starter grip slowly with your
N
right hand until you feel it engage
and then give it a brisk strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
When engine begins to fire
Set the choke lever to e.
N
Continue cranking.
N
64
As soon as the engine runs
Blip the throttle trigger. The slide
N
control moves to the normal run
position F – and the engine settles
down to idle speed.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not run when the engine is idling.
The machine is now ready for operation.
Stopping the engine
Push the slide control in the
N
direction of the arrow on the stop
symbol (h) to STOP-0.
At very low outside temperatures
As soon as the engine runs:
Blip the throttle trigger to disengage
N
the starting throttle position. The
slide control moves to the normal
run F – and the engine settles down
to idle speed.
Open the throttle slightly.
N
Warm up the engine for a short
N
period.
If engine does not start
Choke lever
If you did not move the choke lever to e
quickly enough after the engine began to
fire, the combustion chamber is flooded.
Set the choke lever to e.
N
Set the slide control, lockout lever
N
and throttle trigger to the starting
throttle position.
Start the engine by pulling the
N
starter rope briskly – 10 to 20 pulls
may be necessary.
If the engine still does not start
Move the slide control to STOP-0.
N
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Open the throttle wide.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug – see "Spark
N
Plug".
Move the slide control to START.
N
Set the choke lever to e – even if
N
the engine is cold.
Now start the engine.
N
Throttle cable adjustment
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob to suit the
N
engine temperature.
Start the engine.
N
HT 75
Publicidad
Capítulos
Tabla de contenido
