Stihl HT 75 Manual De Instrucciones página 65

Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
Press down the trigger lockout lever
N
and squeeze the throttle trigger
and hold them in that position.
N
Move the slide control to START
N
and hold it there.
Now release the throttle trigger,
N
slide control and trigger lockout in
that order. This is the starting
throttle position.
8
Set the choke lever (8) to
N
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
HT 75
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
Remove the chain scabbard. Check
N
that the chain is not touching the
ground or any other obstacles.
8
Place the unit on the ground: It must
N
rest securely on the engine support
and the hook. If necessary, rest the
hook on a raised support (e.g. a
branch, mound or something
similar).
WARNING
Check that nobody is standing within the
working range of the pruner.
N
N
9
Do not stand or kneel on the drive tube.
This will bend the telescoping drive tube
and may result in permanent damage.
Alternative method:
N
Make sure you have a safe and
secure footing.
Hold the unit with your left hand on
the fan housing and press it down
firmly – your thumb should be under
the fan housing.
NOTICE
Remove the chain scabbard.
Position the shaft on a branch so
that it is held by the hook.
English
63