Fault - Angelo Po 1G1FA0GV Manual De Uso E Instalación

panel (B).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
7 - Light one of the burners, turn the knob to the full
flame setting (see page ) then check that the
pressure reading is the same as the values pro-
vided in the table (see back of manual).
TROUBLESHOOTING
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
Faults
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The flame is yellow.
Burner control knob is stiff.
8 - Switch off the burner, turn off the gas supply tap
9 - Restore the initial conditions after completing

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowl-
edge or skill is required, and so they must only
be carried out by qualified staff with recog-
nised experience acquired in the specific sec-
tor of operation.
Causes
Occasional leak because flame
has gone out.
The spark ignition devices are not
working.
Air in pipelines due to long period
out of use.
The thermocouple has not warmed
up enough.
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
- 15 -
and disconnect the pressure gauge.
the operation.
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices are
in good working order
Light by hand with a naked light.
Important
Contact the after-sales
service.
Make more attempts
to light the flame.
Make more attempts
to light the flame.
Important
Contact the after-sales
service.
Important
Contact the after-sales
service.
6
Remedies
English
IT
GB
DE
FR
ES