Brother P-touch PT-97OOPC Guia Del Usuario página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lamp condition
Power button
STATUS lamp
(green)
Lit
Flashing fast
Flashing very
Lit
Not lit
■ LED display on USB Direct Interface (PT-9800PCN only)
Lamp condition
Color
Condition
Green
Flashing fast
Red
Flashing very
(red)
Cutter error
Roller holder error
Print head overheat error
EEPROM error
fast
Circuit board error
Lit
Booting
Not lit
USB device not connected
Lit
USB device connected
Flashing
HUB connected
Noncompliant USB device
connected
"Buffer full" error with USB
Direct Interface
Overcurrent
fast
Condition
Condition
Remedy
Confirm that the tape is not jammed
in the printer. If necessary, turn the
printer off and on. If the STATUS
lamp continues to flash, contact the
reseller where the printer was
purchased or call Brother customer
service.
Turn the printer off and on.
Turn the printer off and on. If the
STATUS lamp continues to flash,
contact the reseller where the
printer was purchased or call
Brother customer service.
Remedy
Disconnect USB device.
Disconnect USB device.
Data sent from the barcode reader is
saved on the printer.
Do not use the barcode reader to
consecutively scan barcodes or use
the barcode reader with multiple
interfaces at the same time.
Disconnect USB device and turn the
printer off and on.
13

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

P-touch pt-98oopcn

Tabla de contenido