Fermax KITS EVOLUTION AVISA Manual Instalador página 61

Kits EVOLUTION
Kits EVOLUTION
PROGRAMMING AND CONFIGURING ALARM ZONES
Avisa and Detecta4 are configured and programmed in the factory, so that once the installation and wiring
of each element is carried out (as shown in the Kit wiring diagrams in this Manual), the alarm system works
correctly with no need for any kind of prior programming.
It will only be necessary to reprogram the system if you want a configuration other than the initial configura-
tion of the Kit.
The system leaves the factory with the following configuration:
o monitor address (0x8F00).
o Master code "1234".
o Zones defined as N.C. in instant set off mode.
o General system arming disactivated.
o Alarm zones enabled (sensor entries enabled).
o Zone 1 E/E delay 30 seconds.
o Zones 3 and 4 defined as "normal" zones (not defined as "24-Hour Zones").
o Monodecoder relays timed at 5 seconds.
o "F" button activates the decoder relay.
o System in night mode (no guard unit active).
o Call tone volume high.
o Panel and guard unit call tones are dual-tone.
To change the initial configuration, please check the following sections:
Pag 26