Fermax KITS EVOLUTION AVISA Manual Instalador página 70

Kits EVOLUTION
Kits EVOLUTION
MONITOR CONFIGURATION
CHANGE MASTER CODE
VOLUME LEVEL ''LOW''
VOLUME LEVEL ''HIGH''
AUXILIARY DEVICE ACTIVATION
MULTIFUNCTION
PANIC CALL
BUTTON
(See Table 1) ALARMS RECEPTION CENTRE
RING TONE SELECTION
ALARM ZONE
STATUS
4 Zones Status
Zone 1 Status
Zone 2 Status
Zone 3 Status
Zone 4 Status
If the Zone is configured in «24-Hour Mode» the 3 LEDs light up (green, yellow and red).
MULTIFUNCTION BUTTON CONFIGURATION
RELAY ACTIVATION MODE
PANIC CALL MODE
ALARM CENTRAL MODE
-
Lock release button: Press the button to select the call tone from the Outdoor Panel.
Every time the button is pressed, one of the tunes stored in the monitor memory is heard.
The last tune heard is selected as the ring tone.
- Auto-on button: Press the button to select the call tone from the Outdoor Panel.
1
Every time the button is pressed, one of the tunes stored in the monitor memory is heard.
The last tune heard is selected as the ring tone.
- Multifunction button: Exit «Ring Tone Selection» mode.
F
KEY
SEQUENCE
0*
1*
2*
3*
4*
KEY SEQUENCE
Current Master Code+ AB +
0 + New Master Code
Master Code + AB + 6+0
Master Code + AB + 6+1
Master Code + AB + 7+0
Master Code + AB + 7+1
Master Code + AB + 7+2
Master Code + AB + 8
ACOUSTIC
INFORMATION
+
+
+
+
Table 1
RELAY FUNCTION
Relay is activated by pressing the monitor's «F» button.
Relay is activated when the tamper circuit is (i.e., there is an
open circuit between terminals T and T- of the monitor
connector).
The relay automatically informs the Alarms Reception Centre
on the status of the alarms system (aremd/disarmed).
EXAMPLE
1234AB04321
1234AB60
1234AB61
1234AB70
1234AB71
1234AB72
ZONE STATUS
Enabled Disabled
Lit
2.5 sec. LED ROJO
Lit
2.5 sec.
ELit
2.5 sec.
Lit
2.5 sec.
Lit
2.5 sec.
1234AB8
Off
Off
Off
Off
Off
Pag 35