Fermax KITS EVOLUTION AVISA Manual Instalador página 56

Kits EVOLUTION
Kits EVOLUTION
Monitor telephone LEDs (luminous indicators).
These inform the user:
LED (Colour)
Yellow
Green
Red
NOTES:
1 To activate/deactivate the Do Not Disturb function, press the following key combinations: B#.
With the «Do Not Disturb» function activated, the monitor does not receive calls from the Outdoor Panel.
This function is only possible if an open door sensor has been installed in the Outdoor Panel (please check with your installer).
2
3 If this situation arises, or if the three telephone LEDs stay lit at the same time, please consult your installer.
Message from Guard Unit
If there is a Fermax Guard Unit installed in the building, the guard unit may notify a given user that there is a message for them.
4
The «Message from Guard Unit» is indicated on the monitor by the blinking ''Yellow LED''.
Press the lock release button to contact the Guard Unit (and disconnect the LED alert).
IMPORTANT!!
For greater sytem security, there is a Master Code that must be entered, using the monitor keypad,
to access, modify and activate/deactivate the different functions and options of the Detecta4 and
Avisa systems.
The default Master Code is 1234, configurable. We advise you to change the code for enhanced
security (See ''Change Master Code'' section in this manual).
Every time a code is entered with the monitor keypad, if the code is correct, the monitor emits a
confirmation tone (
Status
Lit
Slow blinking
Fast blinking
Lit
Slow blinking
Fast blinking
Slow blinking
Fast blinking
: Symbolises the confirmation tone).
Meaning
Monitor in «Do Not Disturb»
Message from Guard Unit
Do Not Disturb and Message from Guard Unit
Door open (2)
Audio busy
Device in programming en mode
General Arming activated
Alarm set off
(1)
(4)
(4)
Pag 21