Kemper CleanAirTower Instrucciones De Servicio página 76

Pos. Designation
1 Dust collection container
3 Seal
To do so, proceed as follows:
1. Switch off the product using the on/off switch and wait until the illuminated ring on
the on/off switch stops flashing completely.
2. Disconnect the product from the power supply by pulling out the mains plug and
secure against unintentional restarting.
3. Lift the dust collection container (Pos. 1) slightly (A) until it releases from the magnet
holder (Pos. 2).
4. Pull out the underside of the dust collection container (Pos. 1) far enough (B) so that it
can be pulled down (C) on the magnet holder (Pos. 2). Then remove to the rear (D).
5. Close the opening to the dust collection container (Pos. 3) with the attached sticker
(Pos. 4), which is located on the dust collection container.
6. Reinsert the new dust collection container in reverse order. Please ensure that the seal
(Pos. 3) on the dust collection container (Pos. 1) is not damaged and that the dust
collection container (Pos. 1) is noticeably held by the magnet holder (Pos. 2).
1502828-01
Fig. 35: Changing the dust collection container
Pos.
2
4
Tab. 22: Changing the dust collection container
- 76 -
Designation
Magnet holder
Sticker to close the dust collection
container
EN