Sanyo PLC-SE10 Manual Del Propietário página 27

COMPUTER INPUT
Display area
Selects area displayed with this projector. Select the resolution at
Display area dialog box.
Display area H
Adjustment of horizontal area displayed with this projector. Press
POINT LEFT/RIGHT button(s) to decrease/increase value and then
press SELECT button.
Display area V
Adjustment of vertical area displayed with this projector. Press
POINT LEFT/RIGHT button(s) to decrease/increase value and then
press SELECT button.
Full screen
Press POINT LEFT/RIGHT button(s) to switch Full screen function to
"On" or "Off." Set "On" to resize the image with 4 x 3 aspect ratio to
fit the screen.
NOTE : Fine sync, Total dots, Display area (H/V) and Full screen
cannot be adjusted when "1035i (HDTV)" or "1080i (HDTV)"
is selected on PC SYSTEM Menu (P22).
3
Store
To store adjustment parameters, move a red frame pointer to
Store icon and then press SELECT button. Move a red arrow
pointer to any of Mode 1 to 5 that you want to store to and then
press SELECT button.
Mode free
To clear adjustment parameters previously set, move a red
frame pointer to Mode free icon and then SELECT button. Move
a red arrow pointer to the Mode that you want to clear and then
press SELECT button.
Other icons operate as follows.
Reset
Reset all adjust parameters on adjustment dialog box to previous
figure.
Quit
Closes PC ADJUST MENU.
26
Press SELECT button at
Display area icon and Display
area dialog box appears.
Press POINT LEFT
/RIGHT button(s) to
adjust value and then
press SELECT button.
To store adjustment data.
This Mode has parameters being stored.
Vacant Mode Shows values of "Total dots,"
"Horizontal," "Vertical," "Display
area H," and "Display area V."
Store icon
To clear adjustment data.
Mode free icon
Display area
Close this dialog box.