Preparation; Name Of Each Part Of Projector - Sanyo PLC-SE10 Manual Del Propietário

PREPARATION

NAME OF EACH PART OF PROJECTOR

FRONT
CARRY HANDLE
INFRARED
REMOTE RECEIVER
BACK
TOP CONTROLS
AND INDICATORS
POWER CORD CONNECTOR
BOTTOM
LAMP COVER
ADJUSTABLE FEET
AND
FEET LOCK LATCHES
LENS COVER
PROJECTION LENS
EXHAUST VENTS
HOT AIR EXHAUSTED !
Air blown from Exhaust Vents is hot.
When using or installing projector,
following precautions should be taken.
G Do not put any flammable object near
these vents.
G Keep front grills at least 3'(1m) away
from any object, especially heat-
sensitive object.
G Do not touch this area, especially screw
and metallic part. This area will become
hot while a projector is used.
This projector detects
temperature and automatically controls
operating power of Cooling Fans.
INFRARED
REMOTE RECEIVER
SPEAKER
TERMINALS
AND CONNECTORS
AIR FILTER
AIR INTAKE VENTS
(Back and Bottom)
This projector is equipped with Cooling
Fans for protection from overheating.
Pay attention to the following to ensure
proper ventilation and avoid a possible
risk of fire and malfunction.
G Do not cover vent slots.
G Keep back and bottom clear of any
object. Obstructions may block
cooling air.
internal
7