ABB M25102 K Serie Manual Del Usuario E Instrucciones página 43

ABB-Welcome
5.5 Keypad outdoor station
5.5.1 Call a resident (3 types)
1. Physical address
The physical address is the internal code that the
outdoor station will send through the bus connection
to indoor stations or other devices in the system. For
each apartment, physical address means the address
of an indoor station that is installed in the apartment.
For each building, physical address means the
address of a gateway that is installed for each
building. It is also called the building number.
In standby mode, a visitor can press the physical
address corresponding to the residence (from 001 to
250).
For a complex building, a visitor needs to press the
building number (01- 60) plus the physical address
(001 - 250), or make a call in the gate station.
Enter Physical
Add.:
01 001
2. Logic address
Logic address is a code that a visitor can press to make a call. The code must be
assigned first and then associated with the physical address.
The apartment number or some special codes can be used to set the logic address,
which is easy for the users to remember.
Set the logic address by following these steps:
Assign the logic address:
#* system password #
Contact => Add =>
|
=> system setting
Logic Add.
=>
— 42 —