Tabla de contenido
Publicidad
ABB-Welcome
No.
Functions
1
Connector for camera module
2
Connector for device software update
3
Plug-in clamps (COM-NC-NO) for floating output, door opener (30VAC/DC
1A)
4
Plug-in clamps (Lock-GND) for door opener (18V 4A impulsive, 250 mA
holding)
5
Plug-in clamps (DC-GND) for additional power supply
6
Plug-in clamps (a-b) for bus connection
7
Connector for induction loop module
8
Connector for next module
9
Connector for exit pushbutton
10
Connector for sensor for checking the door status
11
Rotary switch for setting the address of OS (1-9)
12
Set feedback tones for pushbuttons and for outdoor station when making a
call: ON/OFF
13
Configure pushbuttons in a single column or double column mode
(ON=double column; OFF=single column)
It only affects the bar pushbutton, not the round pushbutton.
14
Configure functions of the 1st/2nd pushbuttons.
3->OFF, 4->OFF=call indoor station/call indoor station
3->ON, 4->OFF=switch on lighting/call indoor station
|
— 8 —
Publicidad
Tabla de contenido
