Product Overview; Wiring Overview - Lutron Energi Savr Node 0-10 V Softswitch Guia De Instalacion

Energi Savr Node

Product overview

An Energi Savr Node system consists of an Energi Savr Node unit, output loads, sensors, keypads, and QS interface devices. The
diagram on the previous page shows a typical system topology.
• All lighting loads and Energi Savr Node units are powered by line voltage.
• The Energi Savr Node unit is limited to:
– 4 Lutron daylight sensors (models: EC-DIR-WH)
®
– 4 Lutron occupant sensors (models: Lutron LOS series)
– 4 Lutron infrared (IR) receivers (models: EC-DIR-WH, EC-IR-WH, CC-1BRL-WH, CC-4BRL-WH)
– 4 NEC Class 2/PELV dry contact switch inputs
®
– 1 contact closure input
– 1 emergency contact closure input (defaults to Emergency Mode in the absence of a contact closure across the input)
• The QS Link can have up to 100 zones and 100 devices.
• The Energi Savr Node unit counts as 1 device and 4 zones on the QS link.
• In a system with multiple Energi Savr Node units on a QS link, a maximum of 100 daylight sensors, 100 occupancy sensors,
100 IR receivers, and 100 Pico
• The Energi Savr Node unit supplies up to 14 Power Draw Units (PDUs) for powering accessory QS devices. Refer to accessory device
documentation for power draw information.
Refer to the following step-by-step guide for proper Energi Savr Node unit installation.

Wiring overview

Zone Zone Zone Zone
1 2 3 4
0-10 V Channels
(QSN-4T16-S only)
Lutron 2
|
®
0-10 V / Softswitch
TM
wireless controllers are permitted.
®
Control
power
Input Groups
|
Installation Guide
®
Input power and
switched outputs to loads (4 zones)
Zone Zone Zone
1 2 3
Energi Savr Node
Zone
4
QS
Link
Contact
Closure
Inputs
0-10V / Softswitch Installation Guide
TM ®