Zone Setup; Assigning Load Types; Assigning Non-Dim Load Types - Lutron GRAFIK Eye QS Guía Rápida De Instalación Y Funcionamiento

Zone Setup

Assigning Load Types

1. Enter programming
Main menu
1 2 3 mode. 4
CCI Setup
2. Use the Master
buttons to highlight
Zone setup
"Zone setup" and
press the OK button
to accept.
Zone Setup
3. Use the Master
buttons to highlight
Load Type
"Load type". Press
Non-Dim Load Type
the OK button to
accept. See "Setting
Load Types" table
on the next page.
Load Type
4. Use the zone
raise/lower buttons
Set zones
to choose the
load type for that
zone. See the list
on the next page
for supported load
types. Press the OK
button to accept.
Saved
5. The info screen will
confirm that your
load type has been
saved.
6. Exit programming
mode.
5 6

Assigning Non-Dim Load Types

Zones assigned to non-dim loads have three available configurations:
Main menu
CCI Setup
Zone setup
Zone Setup
Load Type
Non-Dim Load Type
Load Type
For additional information, see the complete installation and operation guide at www.lutron.com/qs
Master
buttons
OK
OK
button
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
• LOLO: Last On, Last Off
• 60/40: On at 60%, off at 40%
In scenes including dim and non-dim load types, if set
up as "First" On/Off, non-dim loads will toggle before dim
loads; if set up as "Last" On/Off, dim loads will toggle
before non-dim loads.
1. Enter programming mode.
2. Use the Master buttons to highlight "Zone setup" and
press the OK button to accept.
3. Use the Master buttons to highlight "Non-Dim Load
type". Press the OK button to accept. See "Setting Load
Set zones
Types" table on the next page.
4. Use the zone raise/lower buttons to choose the non-dim
load type for that zone. (Zones not programmed as
non-dim will be displayed as Unaffected.) Press the OK
button to accept.
5. The info screen will confirm that your load type has been
Saved
saved.
6. Exit programming mode.
GRAFIK Eye QS Control Unit Quick Installation and Operation Guide
1 2 3 4 5 6
Use the
zone
raise/lower
buttons
to choose
the load
type for
that zone.
11