Pico Wireless Control Setup; Associating With A Grafik Eye Qs Wireless Control Unit - Lutron GRAFIK Eye QS Guía Rápida De Instalación Y Funcionamiento

Pico Wireless Control Setup

Associating with a GRAFIK Eye QS Wireless control unit:

(for wireless-enabled GRAFIK Eye QS control units only)
1. Make sure the wireless mode of the GRAFIK Eye QS control unit is
Pico
"Enabled".
Change type?
2. On the Pico wireless control, press and hold the top (on) and
bottom (off) buttons for 3 seconds. The info screen on the GRAFIK
Press OK
Eye QS control unit will display the Pico wireless control options.
Press the OK button on the GRAFIK Eye QS control unit to select
the desired operation type for the Pico wireless control.
Change type?
3. Assign the Pico wireless control
a. To assign the Pico wireless control as a zone controller, use
Zone
the Master buttons to select "Zone" and press the OK button
to accept. Use the zone raise/lower buttons for a zone to select
a desired preset level, and then press the zone raise and lower
OR
buttons simultaneously for 1 second (until the zone LEDs flash at
the programmed preset level). Repeat for all zones you wish to
Change type?
control with the Pico wireless control.
OR
Scene
b. To assign the Pico wireless control as a scene controller, use the
Master buttons to select "Scene" and press the OK button to
accept. Press and hold the top scene button on the GRAFIK Eye
QS control unit for 3 seconds (until the scene LEDs flash).
4. On the Pico wireless control, press and hold the top and bottom
buttons for 3 seconds until the LEDs on the GRAFIK Eye QS
Saved S aved
control unit stop flashing.
Note: The wireless signal has a range of 30 ft (9 m) through
1 9 2 10 3 11
standard construction or 60 ft (18 m) line of sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
4 12 5 13 6 14 7 15 8 16
GRAFIK Eye QS Control Unit Quick Installation and Operation Guide
9-16
1-8
OK
Zone LEDs
Zone Raise
Zone Lower
Pico Wireless Control
Master buttons
OK button
Press and hold the
top scene button for
3 seconds to assign Pico
as a scene controller.
Top/On button
Bottom/Off button
17