Zone Setup; Assigning Load Types; Assigning Non-Dim Load Type - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25

Zone Setup

Assigning Load Types

Load types supported by the GRAFIK Eye
• Digital load
• DMX
• RGB/CMY DMX
• Non-dim digital
Note: For all DMX or RGB/CMY DMX lighting, an external
DMX interface (such as the QSE-CI-DMX) must be
used with the control unit.
1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight
CCI Setup
"Zone setup" and press the
Zone setup
OK button to accept.
3. Use the Master buttons to highlight
"Load type". Press the OK button to
accept.
Zone Setup
4. Use the zone raise/lower buttons to
Load Type
choose the load type for that zone.
Non-Dim Load Type
See the list above for supported
load types. Press the OK button to
accept.
5. The info screen will confirm that
Load Type
your load type has been saved.
Set zones
6. Exit programming mode.
Saved
®
1
9
2
10
3
11
QS with DALI:
®

Assigning Non-Dim Load Type

Zones assigned to non-dim loads have three available configurations:
Main menu
CCI Setup
Zone setup
Zone Setup
Load Type
Non-Dim Load Type
Load Type
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
QS with DALI Control Unit Quick Installation and Operation Guide 12
®
4
12
5
13
6
14
7
15
8
16
1
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
Scenes made up of both dim and non-dim
load types will toggle the non-dim loads
before the dim loads in a "First" on/off
configuration, and after the dim loads in a
"Last" on/off configuration.
1. Enter programming mode.
2. Use the Master buttons to highlight "Zone
setup" and press the OK button to accept.
3. Use the Master buttons to highlight "Non-Dim
Load type". Press the OK button to accept.
Set zones
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone. (Zones
not programmed as non-dim will be displayed
as Unaffected.) Press the OK button to
accept.
5. The info screen will confirm that your load
type has been saved.
Saved
6. Exit programming mode.
9-16
1-8
OK
9
2
10
3
11
4
12
5
13
6
Master
buttons
OK button
14
7
15
8
16
Use the
zone
raise/lower
buttons to
1
choose the
load type for
that zone.

Publicidad

Tabla de contenido
loading

Tabla de contenido