Troubleshooting - JVC RX-ES1SL Manual De Instrucctiones

Troubleshooting

Use this chart to help you solve daily operational problems. If there are any problems you cannot solve, contact your JVC's service center.
RX-ES1SL
PROBLEM
The power does not come on.
No sound from speakers.
Sound from one speaker only.
The unit turns off and becomes standby
mode.
Remote control does not operate as
you intend.
Remote control does not work.
Bass sound is reinforced too much
when listening in stereo.
70
POSSIBLE CAUSE
The power cord is not plugged in.
Speaker signal cables are not connected.
An incorrect source is selected.
Muting is activated.
An incorrect input mode (analog or digital)
is selected.
Connections are incorrect.
The balance is set to one extreme.
Speakers are overloaded because of high
volume.
Speakers are overloaded because of a
short circuit at the speaker terminals.
The unit is overloaded because of a high
voltage.
The remote control is not ready for your
intended operation.
There is an obstruction hiding the remote
sensor on the unit.
Batteries are weak.
The mode selector is set to the incorrect
position.
Appropriate bass level is not selected.
SOLUTION
Plug the power cord into an AC outlet.
Check speaker wiring and reconnect if necessary.
Select the correct source.
Press MUTING to cancel the mute.
Select the correct input mode (analog or digital).
Check connections.
Adjust the balance properly (see page 23).
1. Stop the playback source.
2. Turn on the unit again, and adjust the volume.
Check the speaker wiring.
If speaker wiring is not short-circuited, contact your
dealer.
Consult your dealer after unplugging the power cord.
Press a source selecting button or TONE first, then
press the buttons you want to use. (See pages 22
and 67 – 69.)
Remove the obstruction.
Replace batteries.
Set the mode selector to the proper position.
Adjust audio position level (see page 23).