diversey TASKI swingo 4000 Manual De Instrucciones página 72

Starting the machine using the program button
• By pressing the program button for
the next operation start or work step,
all machine functions are started on
the basis of the functional values last
used.
Notice:
By pressing a button again, the function will be re-
programmed.
Notice:
The preset values can be adjusted at any time
during operation.
The values preset when switching off the machine are
stored and will be automatically activated when restart-
ing the machine.
Notice:
Pressing the program button when the cleaning
process is finished will start an optimized program
for the end of operation. See instructions on page
71 in the "Automatic process" chapter.
Settings and activated functions are saved.
Cleaning start
• If the machine is switched on and the
operator is sitting on the driver seat,
the machine starts moving as soon
as the gas pedal is depressed. If se-
lected, the brush unit is started and
the cleaning solution supply is open.
Notice:
The speed is controlled by the position of the gas
pedal. When releasing the gas pedal, the machine is
decelerated until it stops and the parking brake is
activated. The supply of the cleaning solution will
be interrupted, then the brush unit will be stopped
with a delay.
Notice:
The supply volume of the cleaning solution is ad-
justed to the corresponding working speed. (Intelli-
Flow)
Caution:
When working in restricted or narrow areas, it is
recommended to press the slow approach ON/OFF
button. (Display lights up)
The maximum working speed is reduced, and thus so is
the risk of accidents.
• Pressing this button once more will
override this restriction, and the dis-
play disappears.
Battery capacity - end of operational readiness
The battery level indicator provides information on the available oper-
ating time.
• If the red indicator begins to flash, approx. 5 minutes of
residual working time are left.
• After this period, the brush unit and – 30 seconds later –
70
the squeegee is lifted. The red display switches to continu-
ous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in several work
steps.
Notice:
More precise details regarding the direct and indi-
rect working method can be found on the respec-
tive method sheet.
- Please contact your TASKI customer consultant for
further details.
Notice:
The machine guiding might be impaired in case of
special combinations of flooring/contamination
and cleaning product.
- Optionally available wheels can improve the traction
of the machine on the floor. Please contact your TAS-
KI customer consultant.
Replenishing cleaning solvent
Caution:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
The pump must never run dry for an extended peri-
od.
Notice:
A rattling noise from the pump indicates an empty
fresh water tank (Flextank).
• The fresh water tank display lights
up.
Fresh water tank is empty.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 68.
• Add the cleaning product using the dosing cup.
• Tilt the tank cover back to the original position.
Empty recovery tank
• The recovery tank display lights up.
Recovery tank is full.
• Drain the recovery tank, see page 71.