Batteries - diversey TASKI swingo 4000 Manual De Instrucciones

Batteries

Permissible batteries
Traction batteries are required for the use of this machine (no wet bat-
tery sets, starter or device batteries). We recommend the use of pure
traction batteries. Only these batteries guarantee a long service life.
Traction batteries are produced as closed and maintenance-free (VR-
LA) batteries (gel and AGM, Pure Lead and lithium). The machine
must be adjusted according to each construction type and manufac-
turer.
Each battery has a different service life and performance.
The machine and charger must be programmed after the batteries
have been inserted and when the battery type and/or the manufactur-
er have been changed, as well as prior to starting the machine.
Incorrect adjustment may result in early battery failure.
Notice:
Do not use different, old batteries with new or de-
fective batteries.
Notice:
Old and/or defective batteries must be disposed of
properly. See the information on page 76
Safety measures to be taken when handling
the batteries
Batteries contain acid. Always wear safety goggles
for the maintenance, installation and removal of wet-
cell batteries.
Rinse acid splashes in your eyes or on your skin with
plenty of clear water. Then immediately consult a
doctor. Wash your clothes with water.
Charging batteries creates a dangerous gas mixture.
Keep away from open fire or glowing embers.
Do not smoke!
Danger of acid burns!
Attention! The battery poles are always energized.
Therefore do not deposit any objects on the batteries!
Caution:
Keep batteries clean and dry. Immediately wipe off
leaking acid or water (wet-cell batteries).
- Wear protective gloves for this purpose.
Caution:
Batteries may only be installed by service agencies
or experts approved by Diversey; they must be in-
stalled in compliance with the connection diagram.
Installation and/or connection errors may result in se-
vere injury, explosion and major damage to the ma-
chine and the environment.
Caution:
Provide adequate ventilation when charging the
battery.
Notice:
The product-safety-data-sheet provided by the bat-
tery manufacturer must also be observed.
Notice:
The operating instructions provided by the battery
manufacturer must also be observed.
Caution:
Always disconnect the batteries from the machine
before starting maintenance work.
Battery connection diagram
swingo 4000/5000 (Gel)
Charger
Mains
external
red
Power Board
black
swingo 4000/5000 (Lithium)
Charger
Mains external
red
Power Board
black
In an emergency
Danger:
In the event of an emergency (incorrect functioning
of the machine), the battery disconnection plug
must be pulled out.
24 V
25.6 V
65