Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5
Temporary installation of the
STEP
side walls (Cont'd)
Measure the distance between the front face of the back
wall (14) and the center of the faucet. Then measure the
distance from the top of the bathtub deck to the center of
the faucet.
Using those two measurements mark the position of the
faucet hole on the remaining side wall. Measure from the
side and bottom of the side wall where the retraction pins
are installed.
Repeat this process for all required faucet holes.
Measure twice, drill once !
Record measures below.
Drill a hole from front for the faucets at the previously
marked positions. Pre-drill the hole with the ⅛'' drill bit.
The hole saw size is determined by the faucet type; refer
to the faucet installation manual for hole saw size.
Hole saws can be rented at your
Quick tip
local hardware store or any tool
rental location.
For safe hole saw usage always
pre-drill a hole and wear safety
glasses when drilling.
Back
wall
5.3
Check me!
5.4
Check me!
5.5
Check me!
12
Top view
Faucet
center
Bathtub
deck
Front cut
view
Publicidad
Tabla de contenido
