Final Installation Of Back Wall - MAAX BOSCA 6030 Guia De Instalacion

6

Final installation of back wall

STEP
Remove all walls from the structure.
Clean the bathtub and apply a bead of silicone on the
deck at 3/8" from the back fastening flange. Run the
bead of silicone the entire length of the bathtub and 1''
on each side as well.
Secure the wall to the wall studs with #8 x 1¾ "
screws (not included) in the previously drilled holes.
Also, secure the wall by the fastening flanges on the
side of the wall. Use the pre-dilled holes.
If needed, use shims to keep wall plumb, square
and leveled. (Cut shim excess)
IMPORTANT: HAND TIGHTEN ONLY. DO NOT
OVER-TIGHTEN THE SCREWS.
It is critical for the side wall
installation for there to be at least
⅛'' and no more than ⅜" between
the stud and the X fastener.

Hold the bottom of the back wall
Quick tip with your foot when fastening in
place.
Apply a bead of silicone on both sides of base (13) thres-
hold at 3/8" from the base side fastening flanges.
Apply silicone on both side of the back wall (14) just
before the wall side radius. The silicone applied on the
base and vertically on the back wall must overlap.
6.1
Check me!
6.2
Check me!
⅜"
⅜"
6.3
Check me!
min. "
3/16
max. "
3/8
Stud X fastener
6.4
Check me!
⅜"
14
1"
13
Back
wall
Bathtub
13
14