Installation; Stacking Icemakers - Hoshizaki IM-240DNE-HC Manual De Instalación

Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Top View
Left
15cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the manufacturer cannot be held
responsible.
1) Lay the storage bin on its rear side carefully to prevent
damage. Secure the four adjustable legs (bin accessory)
into the four tapped holes on the underside of the bin.
2) Position the storage bin in the selected permanent position,
and level it in both the left-to-right and front-to-rear
directions.
3) Use the screws provided on the left or right side of the
storage bin to install the top kit.
4) Remove the icemaker panels. The rear panel is not required
to be removed for installation. See "3. UNPACKING".
5) Place the icemaker on the top of the storage bin. Be careful
not to damage the icemaker frame and the bin control
switch.
6) Secure the icemaker to the storage bin at the rear, by using
the mounting brackets and bolts provided.
7) Replace the icemaker panels in their correct position.

6. STACKING ICEMAKERS

Check the icemaker models. A D-type icemaker and an X-type icemaker will be required for stacking two icemakers. A D-type
icemaker and two X-type icemakers will be required when stacking three icemakers. The D-type icemaker is designed for the
upper unit, and the X-type for the middle and lower units.
The D-type and X-type icemakers are provided with two different types of bin control switch. Use the bin control switch of the
lower (and middle) X-type icemakers when stacking icemakers. The bin control switch must be removed from the upper unit.
Misconnection or no connection may cause serious damage to the icemaker units, resulting in failure.
1) Prepare and position the storage bin as detailed in 1), 2) and 3) in "5. INSTALLATION".
2) Remove the icemaker panels. The rear panel is not required to be removed for installation. See "3. UNPACKING".
Rear
30cm
50cm
ICEMAKER
Front
CAUTION
NOTICE
Side View
Top
30cm
Front
Right
ICEMAKER
Bottom
Adjustable Leg
Top Kit
Bolt
5
ENGLISH
Rear
30cm
Adjustable Leg
Icemaker
Mounting
Bolt
Bracket
Mounting
Bracket
Bin