Basic Operations; Daily Operations - JVC GM-P420E Manual De Instrucciones

Basic Operations

Rear View
VIDEO AUDIO VIDEO AUDIO
MONO/L MONO/L
IN OUT R IN Y/C IN R
VIDEO A VIDEO B
DISPLAY
DISPLAY ASPECT
3 VIDEO A
MUTING
MUTING
MENU/EXIT
RM-C576 REMOTE CONTROL UNIT
14
AUDIO OUT
VIDEO AUDIO L
MONO/L MAKE
R
Y/G Pb/B Pr/R HD/Cs VD R IN RS-232C WIRED
COMPONENT/RGB B RGB A REMOTE AUDIO OPTION AC IN POWER
SPEAKER OUT
SPEAKER OUT
R L
( 9 ( 9
1
POWER
POWER
2
VIDEO B COMPO. RGB A
RGB B
4
VOLUME

Daily Operations

1
Turn on the main power.
Set POWER on the back of the Monitor to
The POWER lamp on the upper left of the front panel
glows orange.
2
Turn on the power.
Press POWER on the remote control to turn the power on.
The POWER lamp changes to glow green.
• You can also use the POWER on the front panel (lower
right) to turn on the Monitor.
3
Select an input.
Select the desired input by pressing VIDEO A, VIDEO B,
COMPO./RGB B and RGB A.
• You can also select the input by pressing INPUT on the
Monitor. Each time you press the button, the input
mode changes in sequence.
VIDEO A
RGB A
• Only for GM-P420PCE and GM-P421PCE: You can
select only RGB A.*
Ex. When selecting "VIDEO A" input
V I D E O A
N T S C
Note:
• To select "COMPONENT" or "RGB B," you need to set the
"RGB/COMPO." setting correctly.
4
Adjust the volume.
V O L U M E
–
Note:
• While no menu is displayed, you can adjust the volume by
pressing 2 / 3 on the Monitor.
To turn off the volume immediately
Press MUTING.
"MUTING ON" is displayed, and the sound goes out.
Pressing the button again resumes the previous volume level.
To make the screen indication appear
Press DISPLAY.
The types of input and signal are indicated on the screen for
about 3 seconds.
You can also make the screen indication appear using menus
(page 24).
* Only for GM-P420PCE and GM-P421PCE: You need to
install the video input unit (IF-C422P1G), which is
separately purchased, to select "VIDEO A," "VIDEO B," and
"COMPONENT (or RGB B)" as the input.
ON.
VIDEO B
COMPONENT or RGB B
Input selected
Input video signal
: 1 0
+