Identification Of Manufacturer And Appliance; Procedure For Requesting Service - Angelo Po 1N1FAGV Manual De Uso

IDENTIFICATION OF MANUFACTURER AND APPLIANCE

The nameplate shown here is fi tted directly
to the appliance. It contains references and all
essential information for operating safety.
Extra nameplate
A)
a 1 ) Country of use
a 2 ) Appliance category
a 3 ) Type of gas
a 4 ) Gas pressure
a 5 ) Type of fume exhaust vent
Nameplate
B)
b 1 ) Appliance model
b 2 ) Type of customisation
b 3 ) Manufacturer identifi cation
b 4 ) Serial number
b 5 ) Protection class
b 6 ) EC conformity mark
b 7 ) Reference standard
b 8 ) EC certifi cate number
b 9 ) Product family type
b 10 ) Type of gas
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
3319990_ut_rev.2_GB

PROCEDURE FOR REQUESTING SERVICE

b 11 ) Rated power (kW)
b 12 ) Gas consumption
b 13 ) Testing gas indicator frame
b 14 ) Voltage (V)
b 15 ) Frequency (Hz)
b 16 ) Electricity power consumption (W)
b 17 ) Test voltage indicator
b 18 ) Date of construction
Testing gas plate
C)
c 1 ) Type of gas
c 2 ) Gas pressure
The installer must select the plate (A),and
apply it alongside the nameplate relating to
the country of use, and must mark the rela-
tive appliance class (Type A= standard fume
exhaust vent ).
If the appliance is to be used with the same
type of gas as used by the manufacturer for te-
sting, the installer has to remove the plate (C)
and apply the indicator
the gas for use on the nameplate.
When requesting service, state the data provi-
de on the nameplate and provide a description
of the fault.
- 3 -
against the data of
(b13)
ENGLISH
GB GB