Greasing The Gas Tap; Replacing Parts; Instructions And Warning For Replacing Parts; Replacing The Top Burner Nozzle (Ø 80 - 4 Kw) - Angelo Po 1N1FAGV Manual De Uso

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times..
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F) and the cap (E).
9)
Replace the control panel (B) and the knobs
10)
(A) on completion of the operation.

INSTRUCTIONS AND WARNING FOR REPLACING PARTS

Important
Before carrying out any replacement procedure,
activate all the safety devices provided and deci-
de whether staff at work and those in the vicini-
ty should be informed.
In particular, turn off the gas supply tap and
prevent access to all devices which might cause
unexpected health and safety hazards if turned
on. If work parts have to be replaced, use origi-
nal spare parts only.
REPLACING THE TOP BURNER NOZZLE (Ø 80 - 4 KW)
To carry out this operation, proceed as follows.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
3319990_inst_rev.2_GB

GREASING THE GAS TAP

REPLACING PARTS

A
- 15 -
A
C
B
The manufacturer declines all responsibly for
injury or damage to components due to the
use of non original parts, or extraordinary
work on the appliance which may modify the
safety requirements without the manufactu-
rer's authorisation.
When ordering components, follow the in-
structions provided in the parts catalogue.
B
E
F
C
D
C
GB
8
ENGLISH