Operating The Generator; Basic Notes On Operation - Dometic TEC29 Instrucciones De Uso

Operating the generator

8 Operating the generator
NOTICE!
A
Do not run the generator over 70% of the maximum constant output
for the first 50 operating hours (run-in phase).
NOTE
I
By doing this you can prolong the service life of the generator and
optimise its output:
run the generator at a maximum of approx. 75% of the maximum
continuous load after the run-in phase.
8.1

Basic notes on operation

CAUTION! Beware of injury
!
Do not insert your fingers or objects into the air nozzles or the in-
take grille.
Please note the following basic information:
 Always check the oil level before use ("Checking the oil level" on
page 44).
 TEC29LPG only: Check there are no leaks from the gas supply using a
leak detection spray before every use.
 Even small overloads in the long-run will cause the thermo switch
(TEC29) or the fuses (TEC29LPG) to trigger.
 Leave the generator running for a few minutes after use without any con-
sumers before stopping it.
 Abrupt braking, accelerating and driving round bends in the vehicle can
cause problems in the generator's pump system and lead to unwanted
shutdown.
 If you are not using your generator for a longer period of time, start it up
at least every 30 days and leave it running for 15 minutes or more.
40
TEC29, TEC29LPG
EN