Finishing Maintenance Work - Dometic TEC29 Instrucciones De Uso

Servicing the generator
10.3

Finishing maintenance work

➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. 4 1, page 4).
➤ Close the generator flap.
10.4 Changing the oil (fig. 6, page 5)
CAUTION!
!
Hot oil can cause burns.
NOTICE!
A
Only dispose of used oil at a specialist recycling station and ob-
serve the local laws for environmental protection.
You may use the following oil:
 API SG or SF grade oil for four-stroke engines.
 SAE 10W-30 grade oil (can be used at any temperature).
 Oil with single grade oil viscosity.
Select the appropriate viscosity according to the average temperature on-
site.
Change the oil as follows:
➤ Allow the generator to run until warm so that the oil can drain off faster and
completely.
➤ Place a suitable receptacle under the drain plug (1).
➤ Take out the drain plug (1).
✓ The oil drains off.
➤ Pour fresh oil into the nozzle.
The amount of oil is: 0.6 l.
48
TEC29, TEC29LPG
EN