schmalz SCPSi-L Instrucciones De Funcionamiento página 68

IO-Link Data Dictionary
21.10.01.00065/02

Diagnosis

Error
130 0x0082 Exx Active error code

Counter
140 0x008C cc1 Vacuum-on counter
Valve operating counter
141 0x008D cc2

Condition Monitoring [CM]
146.0 0x0092 Condition monitoring
146.1 0x0092 Condition monitoring
Condition monitoring
146.2 0x0092
146.3 0x0092 Condition monitoring
146.4 0x0092 Condition monitoring
146.5 0x0092 Condition monitoring
Condition monitoring
146.6 0x0092
146.7 0x0092 Condition monitoring
Leakage area
147 0x0093
Evacuation time t
148 0x0094
Evacuation time t
149 0x0095

Energy Monitoring [EM]
155 0x009B Air consumption per cycle in percent
156 0x009C Air consumption per cycle
Energy consumption per cycle
157 0x009D
J. Schmalz GmbH
1 byte
4 bytes
4 bytes
1 Bit
1 Bit
1 Bit
1 Bit
1 Bit
1 Bit
1 Bit
1 Bit
1 byte
2 bytes
0
2 bytes
1
1 byte
2 bytes
2 bytes
J. Schmalz GmbH
Aacher Straße 29, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax: +49(0)7443/2403-259
info@schmalz.de
ro 1-99 = Error code displayed by the device
ro Total number of suction cycles
ro Total number of times the suction valve has been switched on
ro 1 = Valve protection active
ro 1 =Evacuation time t1 above limit [t-1]
ro 1 = Leakage rate above limit [-L-]
ro 1 = H1 not reached in suction cycle
ro 1 =Free-flow vacuum > (H2-h2) but < H1
ro 1 = Primary voltage US outside of optimal range
ro unused
ro 1 = Input pressure outside of operating range
0 = no actual value
1 = Leakage of last suction cycle is >200mbar/s
ro 2 = Leakage of last suction cycle is between 133 ... 200mbar/s
4 = Leakage of last suction cycle is between 67 ... 133mbar/s
8 = Leakage of last suction cycle is <67mbar/s
ro Time from start of suction to H2 (unit: 1 ms)
ro Time from H2 to H1 (unit: 1 ms)
ro Air consumption of last suction cycle (unit: 1 %)
ro Air consumption of last suction cycle (unit: 0.1 Nl)
ro Energy consumption of last suction cycle (unit: 1 Ws)
6 of 11
SCPSi series
29.08.2014
SCPSi Data Dictionary