Scpsi_V2 Data Dictionary 21.10.01.00065_02 2014-08-29.Pdf - schmalz SCPSi-L Instrucciones De Funcionamiento

IO-Link Data Dictionary
21.10.01.00065/02
IO-Link Implementation
Vendor ID
Device ID
SIO-Mode
Baudrate
Minimum cycle time
Processdata input
Processdata output
Process Data
Process Data In
Signal H2 (part present)
Signal H1 (automatic air saving function)
-
CM-Autoset acknowledged
PD In Byte 0
EPC-Select acknowledged
Device status - green
Device status - yellow
Device status - red
PD In Byte 1 EPC value 1
PD In Byte 2 EPC value 2, high-byte
PD In Byte 3 EPC value 2, low-byte
J. Schmalz GmbH
Name Bits
0
1
2
3
4
5
6
7
7...0
7...0
7...0
J. Schmalz GmbH
Aacher Straße 29, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax: +49(0)7443/2403-259
info@schmalz.de
IO-Link Version 1.1
234 (0x00EA) 234 (0x00EA)
100243 (0x018793)
100242 (0x018792)
Yes Yes
38.4 kBd (COM2) 38.4 kBd (COM2)
3.5 ms 3.0 ms
4 byte
1 byte
2 byte
1 byte
Access Availability
ro IO-Link V1.1, V1.0 Vacuum is over H2 & not yet under H2-h2
ro IO-Link V1.1, V1.0 Vacuum is over H1 & not yet under H1-h1
ro - unused
ro IO-Link V1.1, V1.0 Acknowledge that the Autoset function has been completed
Acknowledge that EPC values 1 and 2 have been switched according to
EPC-Select:
ro IO-Link V1.1 only
0 - EPC-Select = 00
1 - otherwise
ro IO-Link V1.1, V1.0 Device is working optimally
ro IO-Link V1.1, V1.0 Device is working but there are warnings
ro IO-Link V1.1, V1.0 Device is not working properly, there are errors
EPC value 1 (byte)
ro IO-Link V1.1 only Holds 8bit value as selected by EPC-Select
(see PD Out Byte 0)
ro IO-Link V1.1 only
EPC value 2 (word)
Holds 16bit value as selected by EPC-Select
(see PD Out Byte 0)
ro IO-Link V1.1 only
1 of 11
SCPSi series
29.08.2014
IO-Link Version 1.0 (legacy mode)
Remark
SCPSi Data Dictionary