Connecting Charger To Power Supply; Charging The Battery - Stihl RMA 370 Manual De Instrucciones

Use the height adjusting lever (1) to
N
raise the mower – the lever is
pushed forwards.
Lower cutting height:
Use the height adjusting lever (1) to
N
push the mower down – the lever is
pushed to the rear.
Push the height adjusting lever (1)
N
against the housing until the
detents (2) engage.
The chosen height setting is indicated by
the front detent (3).
RMA 370
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
Insert the mains plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
2
the first time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 41°F (5°C) and 104°F (40°C).
Push the battery (1) into the
N
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
English
2
15