Fitting The Gate Section Mounting Bracket; Specific Installations - SOMFY IXENGO L Manual De Instalación

Fitting the gate section mounting bracket

Important: On the gate section, measure dimension c (805 mm), the length between the two mounting bracket centres.
Mark the mounting axis for the gate section mounting bracket.
[1] Unlock motor drive rod E.
[2] Temporarily fit the motor drive unit on its mount P.
[3] Fit the two magnets into the magnet holder G.
[4] Insert the magnet holder G into the mounting bracket F.
[5] Fit the gate section mounting bracket F onto the drive rod E.
[6] Check that the motor drive unit E is horizontally aligned using a spirit level.
[7] Attach the gate section mounting bracket F.
tip for respecting dimension c:
Unlock the motor and manually move the knob on the cylinder so that the edge of
the knob is approximately 65 mm from the edge of the cylinder (see the illustration
opposite).
P
After fitting the mounting bracket, insert the drive rod and attach it using ring I.

Specific installations

Installation with a niche in a fence
Copyright © 2008 Somfy SAS. All rights reserved.
F
E
G
Installation with a niche in a gate post
I
7