Loading The Tool - Bostitch TU-216 Serie Manual De Operación Y De Mantenimiento

LOADING THE TU-216
EYE PROTECTION which conforms to ANSI specifications and provides
protection against flying particles both from the FRONT and SIDE should
ALWAYS be worn by the operator and others in the work area when loading,
operating or servicing this tool. Eye protection is required to guard against
flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1-1989 and provide both frontal and side protection. NOTE: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air
supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger while loading the tool.
Loading
1. Turn tool sideways with discharge area pointed away from yourself and others.
Depress the quick release latch inside the tool frame or the latch on the rear of the
main frame. Slide rail to rear.
2. Drop staple stick into magazine.
3. Push rail forward until the latch closes. The tool is now ready for use.
FIG 1
FIG 3
FIG 2
-6-