Loading The P50 Series Stapling Plier - Bostitch P50 Serie Manual De Operación Y De Mantenimiento

EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger while loading the tool.
• Disconnect the air supply before making adjustments
1) Open The Magazine:
Pull cover back until locked by detent pin.
2) Load Staples:
Insert a stick of staples and push forward in the channel.
Insert a second stick of staples.
3) Close magazine:
Push the lock release tab (located at front of magazine cover) down and push the cover
forward until its locked by the detent pin.
MODEL
P50-10B
P50CL-10B
P50CR-10B
P50-10C
P50-5B
*3/8" Staples require special shuttle. See foot note; Page 8 or 9
CAUTION: Do not attempt to operate this plier without material between the shuttle and clincher to
avoid damaging the driver tip.
TRIGGER OPERATED:
The Trigger Operated model is cycled by actuation of the trigger ONLY. This model does not have a Contact
Arm and is intended for use only where a Contact Arm CANNOT be used to satify the requirements of the
application. The Trigger Operated tool will cycle each time the trigger is actuated.
MODEL IDENTIFICATION:
CONTACT TRIP
Identified by:
BLACK TRIGGER

LOADING THE P50 SERIES STAPLING PLIER

MODEL P50 SERIES AIR DRIVE PLIER
CLINCHER BLADE
Standard Clincher
L.H. "C" Blade
R.H. "C" Blade
Standard Clincher
Standard Clincher
SEQUENTIAL TRIP
Identified by:
GRAY TRIGGER
TOOL SPECIFICATIONS
STAPLES
1/2" (12.7mm) Staples SB103020
5/8" (15.9mm) Staples
*3/8" (9.5mm) Staples*
(*3/8" Require special shuttle)
SB103020 Staples 3/8" (9.5mm)
SB5019 Staples 3/8" (9.5mm),
1/2" (12.7mm), 5/8" (15.8mm)
-5-
NOTE:
Use of ANY
other staple leg
lengths in
these models
will damage
tool.
TRIGGER OPERATED
Identified by:
BLACK TRIGGER