Maintenance; Double-Insulated Appliances; Cleaning The Mower Housing; Servicing The Blade - Toro Eurocycler Manual Del Operador

Maintenance

Toro has designed this product to give you years of
trouble-free use. Should it need service, bring the
product to an Authorized Toro Service Dealer.
When the mower is connected to a household
power source, the mower is operational.
Someone could accidentally start the mower
and cause a serious injury to you or other
bystanders.
Always disconnect the mower from the power
source when you leave the mower unattended.

Double-insulated Appliances

In a double-insulated appliance, two systems of
insulation are provided instead of grounding. No
grounding means is provided on a double-insulated
appliance, nor should a means for grounding be
added to the appliance. Servicing a double-insulated
appliance requires extreme care and knowledge of
the system, and should be done only by the qualified
service personnel at an Authorized Toro Service
Dealer. Replacement parts for a double-insulated
appliance must be identical to the parts they replace. A
double-insulated appliance is marked with the words
"Double Insulation" or "Double Insulated." The
symbol (square within a square)
on the appliance.

Cleaning the Mower Housing

After each use, clean the mower housing.
Before cleaning, stop the motor, wait for all moving
parts to stop, and disconnect the mower from the
power source.
Important: Do not clean the mower with water.
Moisture can get trapped in the mower and may
cause corrosion of internal parts.
• Clean the underside of the mower housing.
Remove dirt and grass clippings with a hardwood
scraper.
• Remove the debris from the housing vents along
the top of the mower.
• Brush all the debris off the mower housing.
• Inspect the power plug receptacle for signs of
melting or heating. Old worn-out extension cord
plugs that fit loosely in the plug receptacle can
cause overheating from poor contact. Replace
may also be marked
9
any damaged extension cords immediately (if
applicable) .

Servicing the Blade

Always mow with a sharp blade. As sharp blade cuts
the grass evenly, without tearing or shredding the grass.
When you replace the blade, use only geniune Toro
replacement blades.
Someone could accidentally start the motor
and cause a serious injury to the operator or
to bystanders.
Do not attempt to inspect, remove, or replace
the blade without first disconnecting the
mower from the power source.
1. Stop the motor and wait for all moving parts to
stop.
2. Disconnect the mower from the electrical power
source.
3. Tip the mower onto its side.
4. Carefully examine the blade for sharpness and
wear, especially where the flat and curved parts of
the blade meet. If you notice wear, replace the
blade.
Note: For best performance, install a new blade
before the mowing season begins. During the
season, file down small nicks on the blade to
maintain its cutting edge.
A worn or damaged blade could break and
a piece of blade could be thrown in the
operator's or bystander's direction, causing
serious personal injury or death.
Inspect the blade periodically for wear or
damage, and replace a worn or damaged
blade.