EdilKamin BERING Instalación Uso Y Mantenimiento página 42

STEP 1
D
F
*
STEP 3
Y
*
STEP 5
D
STEP 7
D
INSTALLATION
STEP 2
A
E
D
STEP 4
G
E
STEP 6
STEP 8
- 42
OUTSIDE WALL INSTAL-
LATION OF DOMOKLIMA
GRAPHICA CONSOLE
Material needed (fi g. 1 on page 41):
STEP 1
Bring the wire (*) coming from the boiler
to the point where you wish to position the
console. Position the base for wall fi xing
(F) near the wire coming from the boiler.
Mark the points on the wall where the
plugs must be positioned to fi x the base
(F).
Make two suitable holes in the wall, posi-
tion the 2 plugs (D) and fi x the plastic
base (F) with the 2 screws (make the wire
coming from the wall coincide with the
specifi c hole on the base).
STEP 2
Position the control panel with
display (A) into the seat of the plastic cas-
ing (E).
(N.B. the side with the keys must be posi-
tioned towards the hold in the central part
of the plastic casing).
Press until correctly inserted
STEP 3
Connect the wire to the connector (Y)
positioned on the rear part of the control
panel with display (N.B. take care to cor-
rectly position the connector)
STEP 4
Position the protective plastic cover (G)
on the back of the casing (E), paying at-
tention to the electrical connections.
STEP 5
Fix the protective plastic
cover with 2 self-threading screws pro-
vided (D) (only on the side towards the
opening for the wires).
STEP 6
Apply the plastic casing (E) complete with
control panel, pressing it onto the base
already screwed to the wall and click it
into place.
STEP 7
Apply the self-threading screw provided
(D) to the lower part to fi x the plastic cas-
ing (E) with control panel to the base at
the wall (F).
STEP 8
The control panel thus installed is ready
for use
-